APPI BUSTER / FLY CATCHER
COMPLETE KIT
Summer outdoor fly trap (works from 25 degrees). The fragrant yeasts it contains effectively attract flies and limit the presence of these flying pests outside buildings. Refill your trap with the attractant when it has completely evaporated, otherwise add clear water. Complete kit including bucket, cones and fly attractant.
Packaging: Trap + Refill
ONLY CATCH FLIES
ADVANTAGES
EFFICIENCY: up to 90% reduction of flies
LONG-TERM PROTECTION: up to 60 days
ENVIRONMENTALLY FRIENDLY: no impact on the environment, non-toxic, without harmful products.
ECONOMIC: less expensive to use than other products (insecticides, larvicides, toxic baits, etc.).
PUT IN FULL SUN AT FIFTEEN METERS FROM BUILDING TO PROTECT
PREFERENTIALLY AT 1.50M FROM THE GROUND.
MOVE IT IF THE CATCHES ARE NOT SUFFICIENT
AN EFFECTIVE FLY TRAP EVEN IN CASES OF MASSIVE INFESTATION!
The APPI buster is ideal for places infested with flies.
Its attractant based on fermented yeasts does not contain any biocide, it is 100% natural, without insecticide. This ultra-powerful fly trap can be installed in sensitive places (such as farms, public places, etc.)
HOW TO USE THE FLY BUSTER FLY TRAP
How to use the special breeding fly trap?
Above all, the evaluation of the area to be treated is essential to install a sufficient number of fly traps: 1 bucket every 15 meters at 1m40 from the ground. In order to form a peripheral circle 10-15m from the area to be protected.
How to effectively install the Fly buster trap to fight against a fly infestation?
Completely pour the pot of powdered bait into the bucket.
Add 6 liters of water and shake vigorously.
Position the trap about 1m50 from the ground and about 10-15 meters from the area to be protected.
Each trap protects approximately 200-300 square meters
Good to know: The solution obtained after dissolving the powder in water, needs a period ranging from 24 to 48 hours, depending on the light and temperature conditions, to reach its maximum efficiency. Complete efficiency is faster and optimal at a temperature above 25°C.
How do I maintain my Fly Buster Fly Trap?
After installation, it is advisable to check the effectiveness of the traps, if one trap seems less efficient than another move it. This may be due to poor positioning. Remember to check your traps once a week at the start of treatment then every 10/12 days at the end of treatment. During this check, the maintenance of the fly buster is very important so that it is effective until the end of the treatment.
For it :
Remove surface flies.
Adjust the water level to prevent the solution from drying out, which would destroy the yeasts essential for capture.
Completely empty the trap after 6 weeks, if necessary repeat the operation with a new bottle of concentrated bait.
Can I reuse my Fly Buster fly trap without insecticide?
The Fly buster special breeding fly trap is economical since it is reusable. To keep the same efficiency, it is necessary to clean the traps well with water and a detergent. Improper cleaning will cause a bacterial layer to form on the inside surface of the trap which will mask the smell of yeast fermentation serving as fly bait.
